LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 207 (Automatic Transaxle - 4T65-E - Introduction (2 Of 2)) >> Repair Instructions >> 2-3 Shift Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new O-ring seal (316) onto the 2-3 shift solenoid valve (315B) if the O-ring was removed.
    2. Fig 1: View Of 2-3 Shift Solenoid & O-Ring
    GM49385Courtesy of GENERAL MOTORS CORP.
  2. Install the 2-3 shift solenoid (315B).
  3. Install the 2-3 shift solenoid valve retainer (314C) into the control valve body (301).
  4. Connect the transaxle wiring harness.
  5. Install the case side cover. Refer to Case Side Cover Replacement .
scientia non olet · About LEMON Manuals