Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Tie Rod & Jam Nut

Courtesy of GENERAL MOTORS CORP.

Loosen the tie rod jam nut (2).

Fig 2: Removing/Installing The Torque Prevailing Nut From Outer Tie Rod Stud

Courtesy of GENERAL MOTORS CORP.

Remove the tie rod ball stud nut.

Fig 3: Removing Outer Tie Rod Assembly From Steering Knuckle

Courtesy of GENERAL MOTORS CORP.

NOTE: Do not attempt to free the ball stud by using a pickle fork or wedge type tool, because seal or bushing damage could result. Use the proper tool to separate all ball joints.

Use the J 24319-B to separate the outer tie rod from the steering knuckle. See Special Tools .

Fig 4: View Of Outer Tie Rod & Inner Tie Rod

Courtesy of GENERAL MOTORS CORP.

Remove the outer tie rod (3) from the inner tie rod (1).