Adjustment Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Adjuster Plug Lock Nut (Rack & Pinion)

Courtesy of GENERAL MOTORS CORP.

Loosen the adjuster plug lock nut (1).
Turn the adjuster plug clockwise until the adjuster plug bottoms in the gear assembly.
Turn the adjuster plug back 50 degrees to 70 degrees (approximately one flat).

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the adjuster plug lock nut (1) to the adjuster plug.
Tighten: Hold the adjuster plug stationary while tightening the adjuster plug lock nut (1) to 68 N.m (50 lb ft).