LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 206 (Power Steering System) >> Repair Instructions >> Power Steering Pump Drive Shaft Seal Replacement (CB) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the power steering pump from the vehicle, if necessary. Refer to Power Steering Pump Replacement .
    2. Fig 1: Identifying Power Steering Pump Drive Shaft Seal
    GM1555835Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Protect the drive shaft with the shim stock.
  2. Use a small chisel in order to remove the seal.

    Discard the seal.

scientia non olet · About LEMON Manuals