LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 206 (Power Steering System) >> Repair Instructions >> Power Steering Pump Drive Shaft Seal Replacement (CB) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the new drive shaft seal using power steering fluid.
    2. Fig 1: Identifying Power Steering Pump Drive Shaft Seal
    GM1555838Courtesy of GENERAL MOTORS CORP.
  2. Use a deep socket in order to install the new drive shaft seal.
  3. Install the power steering pump, if removed. Refer to Power Steering Pump Replacement .
scientia non olet · About LEMON Manuals