LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 206 (Power Steering System) >> Repair Instructions >> Power Steering Pulley Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: It is not necessary to completely remove the drive belt from the engine.
  1. Remove the drive belt from the power steering pump pulley. Refer to Drive Belt Replacement for the 3.5L engine or Drive Belt Replacement for the 3.9L engine.
  2. Remove the power steering hoses from the power steering hose retainers.
    3. IMPORTANT: Do NOT disconnect the power steering hoses from the power steering pump.
  3. Remove the bolts from the power steering pump. Refer to Power Steering Pump Replacement .
  4. Raise the power steering pump from the engine and rotate it enough to gain tool clearance.
    5. Fig 1: View Of Pump Pulley
    GM293355Courtesy of GENERAL MOTORS CORP.
  5. Use J 37609-A  to remove the pump pulley. See Special Tools .
scientia non olet · About LEMON Manuals