LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 206 (Power Steering System) >> Repair Instructions >> Power Steering Gear Heat Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Right Side Engine Splash Shield
    GM629009Courtesy of GENERAL MOTORS CORP.
  1. Install the steering gear heat shield.
    2. NOTE: Refer to Fastener Notice .
  2. Install the steering gear heat shield bolts.

    Tighten:  Tighten the steering gear heat shield bolts to 14 N.m (124 lb in).

  3. If the vehicle is equipped with all wheel drive, install the right side engine splash shield. Refer to Splash Shield Replacement - Engine .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals