LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 204 (Front Suspension System) >> Repair Instructions >> Steering Knuckle Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the knuckle to the vehicle.
    2. Fig 1: View Of Steering Knuckle To Strut Bolts
    GM385564Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts which connect the strut to the knuckle.

    Tighten:  Tighten the strut to knuckle bolts to 123 N.m (90 lb ft).

  3. Install the outer tie rod to the steering knuckle. Refer to Rack and Pinion Outer Tie Rod End Replacement in Power Steering.
  4. Connect the front lower control arm ball stud to knuckle. Refer to Lower Control Arm Replacement .
  5. Install the front wheel drive shaft bearing. Refer to Wheel Bearing/Hub Replacement - Front .
  6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals