LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 204 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement (FWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Insulator Brackets
    GM357447Courtesy of GENERAL MOTORS CORP.
  1. Install stabilizer shaft going in through left side of vehicle.
  2. Install the left and right stabilizer shaft insulators and brackets. Refer to Stabilizer Shaft Insulator Replacement .
    3. Fig 2: Identifying Stabilizer Shaft Components
    GM1544893Courtesy of GENERAL MOTORS CORP.
  3. Install the left and right stabilizer shaft links to the stabilizer shaft.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the stabilizer shaft link lower nut (3).

    Tighten:  Tighten the nut to 23 N.m (17 lb ft).

  5. Install the left front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals