LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 204 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement (FWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
    3. Fig 1: Identifying Stabilizer Shaft Components
    GM1544893Courtesy of GENERAL MOTORS CORP.
  3. Remove the stabilizer shaft link upper nut (1).
  4. Remove the stabilizer shaft link lower nut (3).
  5. Remove the stabilizer shaft link (2) from the suspension strut and stabilizer shaft.
scientia non olet · About LEMON Manuals