LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 204 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement (FWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Stabilizer Shaft Components
    GM1544893Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer link (2) to the suspension strut and stabilizer shaft.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the stabilizer shaft link upper nut (1).

    Tighten:  Tighten the nut to 23 N.m (17 lb ft).

    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the stabilizer shaft link lower nut (3).

    Tighten:  Tighten the nut to 23 N.m (17 lb ft).

  4. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals