Installation Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Install the left and right side stabilizer shaft insulators (1) to the stabilizer shaft (2).
- Install the left and right side stabilizer shaft insulator brackets.
- Install the left and right side stabilizer shaft insulator bracket bolts.
Tighten: Tighten the stabilizer shaft insulator bracket bolts to 48 N.m (35 lb ft).
- Lower the vehicle.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.