LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Engine Mechanical - 3.5L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Valve Lifter Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Lifter Guide
    GM61836Courtesy of GENERAL MOTORS CORP.
  1. Coat the valve lifters with prelube GM P/N 1052367 (Canadian P/N 992869) or equivalent.
  2. Install the valve lifters to the same location from which they were removed.
  3. Install the valve lifter guides.
    4. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the valve lifter guide bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    5. Fig 2: Intake Manifold Oil Splash Shield
    GM645872Courtesy of GENERAL MOTORS CORP.
  5. Install the intake manifold oil splash shield
  6. Install the valve rocker arms and pushrods. Refer to Valve Rocker Arm and Push Rod Replacement .
  7. Install the lower intake manifold. Refer to Intake Manifold Replacement - Lower .
scientia non olet · About LEMON Manuals