Installation Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- If the PCV valve was cleaned:
- Install the PCV baffle (2).
- Install the PCV baffle screws (1).
Tighten: Tighten the screws to 6 N.m (53 lb in).
- Install the left valve rocker arm cover. Refer to Valve Rocker Arm Cover Replacement - Left .
NOTE:
Refer to Fastener Notice
in Cautions and Notices.