LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Engine Mechanical - 3.5L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Oil Pump Drive Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Oil Pump, Drive Bolt, & Clamp
    GM190531Courtesy of GENERAL MOTORS CORP.
  1. Install the oil pump drive seal. Coat the seal or bore in the engine block with engine oil.
  2. Coat the drive gear on the oil pump drive with prelube GM P/N 1052367 (Canadian P/N 992869) or the equivalent.
  3. Install the oil pump drive.
  4. Install the oil pump drive clamp.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the oil pump drive bolt.

    Tighten:  Tighten the bolt to 36 N.m (27 lb ft).

  6. Install the lower intake manifold. Refer to Intake Manifold Replacement - Upper .
scientia non olet · About LEMON Manuals