LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Engine Mechanical - 3.5L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Strut Bracket Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Lower Engine Mount Strut Bracket Bolt
    GM155767Courtesy of GENERAL MOTORS CORP.
  1. Position the right engine mount strut bracket over the pin locator.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the lower engine mount strut bracket bolt through the right engine mount strut bracket into the cylinder block.

    Tighten:  Tighten the engine mount strut bracket bolt to 50 N.m (37 lb ft).

  3. Install the vertical engine mount strut bracket bolt through the right engine mount strut bracket to the cylinder head.

    Tighten:  Tighten the engine mount strut bracket bolt to 50 N.m (37 lb ft).

  4. Install the air conditioning compressor. Refer to Compressor Replacement in HVAC Systems - Manual.
  5. Install the drive belt. Refer to Drive Belt Replacement .
  6. Install the engine wiring harness bracket bolt.

    Tighten:  Tighten the engine wiring harness bracket bolt to 13 N.m (110 lb in).

    7. Fig 2: Identifying Engine Mount Strut Bracket Bolt
    GM190592Courtesy of GENERAL MOTORS CORP.
  7. Install the engine oil cooler coolant line bracket bolt, if equipped.
    8. Fig 3: Locating Bolt & Nut For Engine Mount Strut At Right Engine Mount Strut Bracket
    GM105887Courtesy of GENERAL MOTORS CORP.
  8. Install the right engine mount strut to the right engine mount strut bracket. Refer to Engine Mount Strut Replacement - Right .
scientia non olet · About LEMON Manuals