LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Engine Mechanical - 3.5L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Replacement - Right >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the throttle body air inlet duct. Refer to Air Cleaner Intake Duct Replacement in Engine Controls - 3.5L.
  2. Remove the engine mount struts. Refer to Engine Mount Strut Replacement - Left  and Engine Mount Strut Replacement - Right .
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  4. Remove the catalytic converter from the engine exhaust manifold. Refer to CATALYTIC CONVERTER REPLACEMENT in Engine Exhaust.
  5. Remove the right front wheel and tire. Refer to Tire and Wheel Removal and Installation .
  6. Remove the right engine splash shield. Refer to Splash Shield Replacement - Engine in Body Front End.
    7. Fig 1: Identifying Engine Mount Lower Nuts
    GM96002Courtesy of GENERAL MOTORS CORP.
  7. Remove the engine mount lower nuts.
    8. NOTE: In order to avoid oil pan damage and possible engine failure, insert a block of wood that spans the width of the oil pan bottom between the oil pan and the jack support.
  8. Use a utility stand and a block of wood in order to raise the engine.
    9. Fig 2: Identifying Engine Mount Bracket To Oil Pan Bolts
    GM96007Courtesy of GENERAL MOTORS CORP.
  9. Remove the engine mount bracket-to-oil pan bolts.
  10. Remove the engine mount and the engine mount bracket.
    11. Fig 3: Identifying Engine Mount Upper Nuts
    GM96010Courtesy of GENERAL MOTORS CORP.
  11. Remove the engine mount from the engine mount bracket.
scientia non olet · About LEMON Manuals