LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Engine Mechanical - 3.5L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Flywheel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Holding Flywheel
    GM309963Courtesy of GENERAL MOTORS CORP.
  1. Remove the automatic transaxle. Refer to Transmission Replacement (M15) or Transmission Replacement (M76) in Automatic Transaxle - 4T40-E/4T45-E.
  2. Use the J 37096  to secure the flywheel in order to prevent the crankshaft from rotating. See Special Tools .
    3. Fig 2: Identifying Engine Flywheel & Components
    GM54396Courtesy of GENERAL MOTORS CORP.
  3. Loosen the 6 flywheel bolts.
  4. Remove 5 of the 6 flywheel bolts leaving one bolt at the top of the crankshaft rotation.
  5. Grip the flywheel and remove the remaining bolt. Do not drop the flywheel when removing the final bolt.
  6. Remove the engine flywheel retainer and the flywheel.
  7. Clean the engine flywheel bolt threads and bolt holes.
scientia non olet · About LEMON Manuals