LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Engine Mechanical - 3.5L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Balancer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply sealant GM P/N 12378521 (Canadian P/N 88901148) or the equivalent, to the keyway of the balancer.
    2. Fig 1: Installing J 29113 Onto Crankshaft
    GM909647Courtesy of GENERAL MOTORS CORP.
  2. Install the crankshaft balancer. Use the J 29113  . See Special Tools .
  3. Remove the J 29113  . See Special Tools .
  4. Install the J 37096  to the flywheel to prevent flywheel rotation. See Special Tools .
    5. Fig 2: View Of Crankshaft Balancer Bolt & Washer
    GM909519Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the crankshaft balancer washer and the bolt.

    Tighten:  Tighten the bolt to 160 N.m (118 lb ft).

  6. Remove the J 37096  from the flywheel. See Special Tools .
  7. Install the torque converter cover. Refer to Torque Converter Cover Replacement in Automatic Transaxle - 4T65-E.
  8. Raise the frame to the original position.
  9. Install and tighten the frame bolts. Refer to Frame Replacement - Front in Frame and Underbody.
  10. Install the right engine splash shield. Refer to Splash Shield Replacement - Engine in Body Front End.
  11. Install the right front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  12. Lower the vehicle.
  13. Install the drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals