LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Engine Mechanical - 3.5L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Camshaft Rear Bearing Hole Plug Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine flywheel. Refer to Engine Flywheel Replacement .
    2. Fig 1: View Of Camshaft Rear Bearing Hole Plug
    GM105921Courtesy of GENERAL MOTORS CORP.
  2. Remove the camshaft rear bearing hole plug.
scientia non olet · About LEMON Manuals