LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Engine Mechanical - 3.5L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Oil Pan Installation

Oil Pan Installation

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Illustrating Proper Sealer Application
    GM61840Courtesy of GENERAL MOTORS CORP.
  1. Apply sealer GM P/N 12378521, (Canadian P/N 88901148) or the equivalent to both sides of the crankshaft rear main bearing cap (1). Press sealer into gap using a putty knife.
    2. Fig 2: View Of Oil Pan & Bolts
    GM187041Courtesy of GENERAL MOTORS CORP.
  2. Install the oil pan gasket.
  3. Install the oil pan.
    4. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the oil pan bolts.

    Tighten:  Tighten the oil pan bolts to 25 N.m (18 lb ft).

  5. Install the oil pan side bolts.

    Tighten:  Tighten the oil pan side bolts to 50 N.m (37 lb ft).

    6. Fig 3: View Of Oil Pan Drain Plug
    GM909511Courtesy of GENERAL MOTORS CORP.
  6. Install the oil pan drain plug.

    Tighten:  Tighten the oil pan drain plug to 25 N.m (18 lb ft).

scientia non olet · About LEMON Manuals