LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Engine Mechanical - 3.5L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Oil Level Indicator and Tube Removal

Oil Level Indicator and Tube Removal

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Thermostat Bypass Pipe Hose And Thermostat Bypass Pipe
    GM909552Courtesy of GENERAL MOTORS CORP.
  1. Remove the thermostat bypass pipe hose from the thermostat bypass pipe.
    2. IMPORTANT: Passenger cars will have a 16 pin connector attached to the bypass pipe. Passenger vans will have the connector attached to the drive belt shield.
  2. Remove the 16 pin connector.
  3. Remove the spark plug wires from the spark plugs and set aside.
  4. Remove the spark plug wire clip from the pipe.
  5. Remove the heated oxygen sensor connector from pipe.
  6. Remove the thermostat bypass pipe to throttle body nuts.
  7. Remove the thermostat bypass pipe to throttle body bolt.
  8. Remove the thermostat bypass pipe to engine front cover bolt.
  9. Remove the thermostat bypass pipe.
    10. Fig 2: View Of Oil Level Indicator & Tube
    GM909555Courtesy of GENERAL MOTORS CORP.
  10. Remove the oil level indicator tube bolt.
  11. Remove the oil level indicator and oil level indicator tube.
scientia non olet · About LEMON Manuals