LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Engine Mechanical - 3.5L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Crankshaft Balancer Removal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Crankshaft Balancer Bolt & Washer
    GM909519Courtesy of GENERAL MOTORS CORP.
  1. Remove the crankshaft balancer bolt and washer.
    2. Fig 2: Removing Crankshaft Balancer
    GM909522Courtesy of GENERAL MOTORS CORP.
    NOTE: Do NOT use a power-assisted tool with the special tool in order to remove or install this component. You cannot properly control the alignment of this component using a power-assisted tool and this can damage the component.
  2. Remove the crankshaft balancer using the J 41816-A  along with EN 46359  or equivalent. See Special Tools .
scientia non olet · About LEMON Manuals