LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 202 (Frame And Underbody) >> Repair Instructions >> Trailer Hitch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Trailer Hitch Assembly
    GM880018Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the trailer hitch onto the vehicle.

    Tighten: 

    • Tighten all 0.5 in diameter carriage bolts to 101 N.m (75 lb ft)
    • Tighten all M10 bolts to 54 N.m (40 lb ft).

  2. Fig 2: View Of Automatic Level Control Compressor Assembly
    GM187281Courtesy of GENERAL MOTORS CORP.
  3. Install the automatic level control compressor assembly onto the vehicle. Refer to Automatic Level Control Air Compressor Air Filter Replacement in Automatic Level Control.
  4. Install the rubber grommet onto the rear exhaust hanger.
  5. Lower the vehicle.