LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 202 (Frame And Underbody) >> Repair Instructions >> Frame Cushion or Insulator Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the steering intermediate shaft. Refer to Intermediate Steering Shaft Replacement .
  3. Install a jackstand under the center of the frame, between the front frame insulators.
    4. Fig 1: View Of Front Frame Bolts And Retainers
    GM319188Courtesy of GENERAL MOTORS CORP.
  4. Remove the front frame bolts and retainers.
  5. Lower the front of the frame.
  6. Remove the frame front upper insulators.
    7. Fig 2: View Of Frame Front Upper Insulators
    GM777204Courtesy of GENERAL MOTORS CORP.
  7. Install the J 45296  to the front frame insulator you are removing. See Special Tools .
  8. Using J 45296  , remove the front frame insulator from the frame. See Special Tools .
scientia non olet · About LEMON Manuals