LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 202 (Frame And Underbody) >> Repair Instructions >> Frame Cushion or Insulator Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the front frame insulator opening.
  2. Apply a thin coat of rubber lubricant GM P/N 1051717 (Canadian P/N 5728223) or equivalent to the inside of the front frame insulator opening.
  3. Apply a thin coat of rubber lubricant GM P/N 1051717 (Canadian P/N 5728223) or equivalent to the front frame insulator.
    4. Fig 1: Aligning The Front Frame Insulator
    GM777205Courtesy of GENERAL MOTORS CORP.
  4. Align the front frame insulator to the front frame opening with the front frame alignment tabs facing to the front.
  5. Using J 45296  , install the front frame insulator to the front frame. See Special Tools .
    6. Fig 2: View Of Front Frame Bolts And Retainers
    GM319188Courtesy of GENERAL MOTORS CORP.
  6. Install the frame front upper insulators.
  7. Raise the front of the frame.
    8. NOTE: Refer to Fastener Notice .
  8. Install the front frame bolts and retainers.

    Tighten:  Tighten the bolts to 130 N.m (96 lb ft).

  9. Remove the jackstand.
  10. Connect the steering intermediate shaft. Refer to Intermediate Steering Shaft Replacement .
  11. Lower the vehicle.
scientia non olet · About LEMON Manuals