Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Generator Bracket Bolts

Courtesy of GENERAL MOTORS CORP.

Install the generator bracket.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the generator bracket bolts.
Tighten: Tighten the generator bracket bolts in the sequence shown to 50 N.m (37 lb ft).
Install the drive belt tensioner. DRIVE BELT TENSIONER REPLACEMENT in Engine Mechanical-3.5L.
Install the generator. Generator Replacement (LX9) .