Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Battery & Cables

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE .

IMPORTANT: Clean any existing corrosion from the battery terminal bolt flange and the battery cable end.

Install the battery ground (negative) cable (2) to the battery.
Tighten: Tighten the battery terminal bolt to 16 N.m (12 lb ft).
Reprogram the radio presets. Refer to RADIO SETUP .
Re-initialize the power sliding doors. Refer to PROGRAMMING AND SETUP .