LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 201 (Battery, Charging System And Starting System) >> Diagnostic Information and Procedures >> DTC B1516 >> Conditions for Clearing the MIL/DTC

Conditions for Clearing the MIL/DTC

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

The DTC clears as a current status when the battery sensed current returns to normal range for more than 15 seconds.

DTC B1516

Step Action Values Yes No
1 Did you perform the Diagnostic System Check - Vehicle? - Go to Step 2  Go to Diagnostic System Check - Vehicle
2
  1. Install a scan tool.
  2. Start the engine.
  3. With a scan tool observe the Battery Current Sensor parameter in the body control module (BCM) data list.
Does the scan tool indicate that the parameter is within the specified range?		 Less than 4-96% Go to Step 3  Go to Charging System Test 
3 Inspect for poor connections at the harness connector of the battery current sensor. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .
Did you find and correct the condition?		 - Go to Step 5  Go to Step 4 
4 Replace the battery current sensor. Refer to Battery Current Sensor Replacement .
Did you complete the replacement?		 - Go to Step 5  -
5
  1. Use the scan tool in order to clear the DTC.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 - Go to Step 2  System OK
scientia non olet · About LEMON Manuals