LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Control System - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Throttle Body Assembly (L26)
    GM911046Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP purge valve (3).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the EVAP purge valve bolt (2).

    Tighten:  Tighten the bolt to 12 N.m (106 lb in).

  3. Connect the EVAP canister purge valve electrical connector.
    4. Fig 2: Female Connector & Fuel Rail Pipe
    GM910914Courtesy of GENERAL MOTORS CORP.
  4. Connect the EVAP canister purge valve purge pipe (2). Refer to CELL LINK  .
  5. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical - 3.8L.
scientia non olet · About LEMON Manuals