LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 199 (Stationary Window System) >> Repair Instructions >> Weatherstrip Replacement - Swing Out Window >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Swing Out Window Weatherstrip
    GM1480113Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The weatherstrip marked as LH has 2 yellow dots and the weatherstrip marked RH has 2 pink dots at the joint (2).
  1. Position the left hand side weatherstrip end 50 mm (1.96 in) from the lower forward corner of the window opening.
  2. Using a roller-type tool, begin at (2) and roll the weatherstrip (1) forward up the vertical window opening edge on the pinchweld and continue around the periphery of the entire flange back to (2).
  3. Ensure there are no wrinkles and the window corners are secured to the flange radius.
  4. Install the body side quarter window into the opening. Refer to Quarter Window Replacement (With A20 Power)  or Quarter Window Replacement (Without A20 Manual) .
scientia non olet · About LEMON Manuals