LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 199 (Stationary Window System) >> Repair Instructions >> Stationary Window Replacement - Sliding Door >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Stationary Window
    GM1480104Courtesy of GENERAL MOTORS CORP.
  1. Install the stationary window (2) into the opening. Refer to Urethane Adhesive Installation of Bodyside Stationary Windows .
  2. Install the sliding door garnish molding. Refer to Garnish Molding Replacement - Sliding Door in Doors.
  3. Remove the double layer of masking tape around the perimeter of the painted surfaces (1).
  4. Vent the front door windows until the sliding door window urethane has cured.
  5. Install either the 40A, RH or LH power sliding door fuse to the I/P fuse block in order to enable the power to the power sliding door motor.
  6. Perform the re-initialization procedure. Refer to Actuator Control Module - Power Sliding Door (PSD) Programming and Setup .
  7. Close the sliding door.
scientia non olet · About LEMON Manuals