LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 199 (Stationary Window System) >> Repair Instructions >> Quarter Window Replacement (Without A20 Manual) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Quarter Window Components
    GM1232910Courtesy of GENERAL MOTORS CORP.
  1. Install the bushings.
  2. Install the retainers.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bodyside window latch hinge screw to the window.

    Tighten:  Tighten the screw (2) to 1.6 N.m (1.4 lb in).

  4. Install the bodyside window in the opening.
  5. Install the bodyside window hinge nuts (2) to the body.

    Tighten:  Tighten the nuts (2) to 3.5 N.m (1.6 lb in).

  6. Use J 34946  or equivalent in order to install the latch hinge pin. See Special Tools .
  7. Install the bodyside window latch hinge pin (4) to the latch (3).
  8. Inspect the bodyside window for proper operation.
  9. Close the bodyside window.
  10. Install the body side rear upper garnish molding. Refer to Trim Panel Replacement - Body Lock Pillar Upper in Interior Trim.
  11. Install the bodyside window garnish molding. Refer to Finish Panel Replacement - Upper Rear Trim in Interior Trim.
  12. Remove the masking tape from around the perimeter of the painted surfaces and inner trim of the window.
scientia non olet · About LEMON Manuals