LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 198 (Wiper System & Washer System) >> Repair Instructions >> Wiper Blade Element Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Wiper Blade
    GM429895Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Keep the wiper blade claws in the rubber claw channel of the wiper blade element. Do not allow the claws of the wiper blade to contact the metal spline of the wiper blade element.
  1. Insert the open end of the wiper blade element into the bottom claws of the wiper blade.
  2. Guide the wiper blade element through the wiper blade claw sets.
    3. Fig 2: View of Wiper Blade & Wiper Arm
    GM429898Courtesy of GENERAL MOTORS CORP.
  3. Engage the bottom claw of the wiper blade into the notches in wiper blade element.
  4. Install the wiper blade onto the wiper arm. Refer to Wiper Arm Blade Replacement .
scientia non olet · About LEMON Manuals