Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Rear Wiper Assembly

Courtesy of GENERAL MOTORS CORP.

Install the rear wiper blade onto the rear wiper arm. Refer to Wiper Arm Blade Replacement - Rear .
Position the rear wiper arm onto the wiper motor pivot shaft 45 mm (1.77 in) from the bottom edge of the glass (1).
NOTE: Refer to Fastener Notice in Cautions and Notices.
Install the rear wiper arm nut.
Tighten: Tighten the nut to 25 N.m (19 lb ft).
Connect the rear wiper arm finish cover (3).
Inspect the rear wiper system for proper operation.