LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 197 (Engine Cooling System) >> Repair Instructions >> Coolant Heater Cord Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Coolant Heater & Heater Cord
GM1680663Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to VEHICLE LIFTING CAUTION .
  2. Disconnect the coolant heater cord (1) from the coolant heater.
  3. Remove coolant heater cord clip (3) from transaxle bracket.
    4. Fig 2: View Of Coolant Heater Cord Tie Straps
    GM1680726Courtesy of GENERAL MOTORS CORP.
  4. Cut the coolant heater cord tie strap (2) securing the cord to the engine harness.
    5. Fig 3: View Of Coolant Heater Cord Tie Strap
    GM1644186Courtesy of GENERAL MOTORS CORP.
  5. Cut the coolant heater cord tie straps (1) securing the cord to the engine harness.
  6. Lower the vehicle.
  7. Cut the tie strap (1) securing the coolant heater cord to the diagonal brace.
  8. Remove the coolant heater cord.
scientia non olet · About LEMON Manuals