Brace Replacement - Sheet Metal Diagonal (Chevrolet)
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
Brace Replacement - Sheet Metal Diagonal (Chevrolet)
| Callout | Component Name |
|---|---|
|
NOTE:
Refer to Fastener Notice
. Fastener Tightening Specifications:
Refer to Fastener Tightening Specifications . |
|
| Front End Sheet Metal Right Diagonal Brace Replacement | |
| 1 | Block Assembly, Accessory Wiring Junction Refer to Underhood Electrical Center or Junction Block Replacement . |
| 2 | Bolt, Front End Sheet Metal Diagonal Brace Tighten: 47 N.m (35 lb ft) |
| 3 | Bolt, Front End Sheet Metal Diagonal Brace Tighten: 14 N.m (124 lb in) |
| 4 | Brace, Front End Sheet Metal Diagonal |
| Front End Sheet Metal Left Diagonal Brace Replacement | |
| 5 | Reservoir Assembly, Coolant Recovery Refer to Coolant Recovery Reservoir Replacement . |
| 6 | Bolt, Front End Sheet Metal Diagonal Brace Tighten: 47 N.m (35 lb ft) |
| 7 | Bolt, Front End Sheet Metal Diagonal Brace Tighten: 14 N.m (124 lb in) |
| 8 | Brace, Front End Sheet Metal Diagonal |