LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 195 (Bumper System) >> Repair Instructions >> Splash Shield Replacement - Rear Bumper Fascia >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the rear bumper fascia splash shield to the rear bumper fascia.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: View Of Rear Bumper Fascia Splash Shield
    GM735241Courtesy of GENERAL MOTORS CORP.
  2. Install the rear bumper fascia splash shield screws to the rear bumper fascia splash shield.

    Tighten:  Tighten the rear bumper fascia splash shield screws to 2 N.m (18 lb in).

  3. Install the push-in the retainer to the lower rear bumper fascia splash shield.
scientia non olet · About LEMON Manuals