LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 195 (Bumper System) >> Repair Instructions >> Fascia Replacement - Front Bumper (Pontiac) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the DRL lamps to the fascia, connect the wiring as fascia is put on the vehicle
  2. Position the energy absorber (5) to the lower fascia (3).
  3. Install the screws (4) in order to secure the energy absorber to the lower fascia.
    4. Fig 1: Identifying Front Energy Absorber (Pontiac)
    GM1545462Courtesy of GENERAL MOTORS CORP.
  4. Align the front bumper fascia (2) to the front impact bar and to the body.
  5. Install the push-in retainers (1) to the upper front bumper fascia.
    6. Fig 2: Identifying Front Bumper Fascia Fasteners
    GM1479985Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Secure both rear upper corner fascia fasteners.

    Tighten:  Tighten the fasteners to 3 N.m (27 lb in).

  7. Install both front headlamps. Refer to Headlamp Assembly or Headlamp Bulb Replacement in Lighting Systems.
  8. Install the right and left front fender liner. Refer to Wheelhouse Liner Replacement - Front in Body Front End.
  9. Install both of the front tires and wheels. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals