LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 195 (Bumper System) >> Repair Instructions >> Energy Absorber Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Rear Bumper Energy Absorber
    GM1544781Courtesy of GENERAL MOTORS CORP.
  1. Position the energy absorber to the rear bumper fascia and snap in place.
  2. Position the rear fascia to the impact bar.
  3. Connect the rear object sensor wiring harness to the rear energy absorber, if equipped.
  4. Install the rear bumper fascia. Refer to Fascia Replacement - Rear Bumper (Pontiac) , Fascia Replacement - Rear Bumper (Buick)  or Fascia Replacement - Rear Bumper (Chevrolet) .
scientia non olet · About LEMON Manuals