LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 195 (Bumper System) >> Repair Instructions >> Energy Absorber Replacement - Front (Buick) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Front Energy Absorber Components (Buick)
    GM1545456Courtesy of GENERAL MOTORS CORP.
  1. Position the energy absorber to the lower fascia.
  2. Install NEW screws (4) in order to secure the energy absorber to the lower fascia.
  3. Position the front bumper fascia to the vehicle.
  4. Install the front bumper fascia. Refer to Fascia Replacement - Front Bumper (Buick) , Fascia Replacement - Front Bumper (Chevrolet)  or Fascia Replacement - Front Bumper (Pontiac) .
scientia non olet · About LEMON Manuals