LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 192 (Theft Deterrent System) >> Diagnostic Information and Procedures >> DTC P1626 >> Test Description

Test Description

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  To set this code, the password that the PCM has learned does not agree with the password being received from the BCM. This condition can occur if the BCM has been replaced and the programming theft deterrent system components procedure has not been performed.
  2. 4:  If the PCM resets the DTC after the programming theft deterrent system components procedure has been performed, the BCM is malfunctioning.
DTC P1626

Step Action Yes No
Schematic Reference: Theft Deterrent System Schematics 
Connector End View Reference: Theft Deterrent System Connector End Views 
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2 
IMPORTANT: If a 10-Minute or 30-Minute Relearn Procedure is performed, all keys not learned at that time will be erased and will not be recognized. Perform the Adding Keys procedure on all keys or instruct the customer how to perform the Adding Keys procedure. Refer to Adding Keys (Domestic)  or Adding Keys (Export including Canada) .
Perform the Programming Theft Deterrent System Components procedure. Refer to Programming Theft Deterrent System Components .Is the procedure complete?		 Go to Step 3  -
3
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 Go to Step 4  System OK
4 
IMPORTANT: If a 10-Minute or 30-Minute Relearn Procedure is performed, all keys not learned at that time will be erased and will not be recognized. Perform the Adding Keys procedure on all keys or instruct the customer how to perform the Adding Keys procedure. Refer to Adding Keys (Domestic)  or Adding Keys (Export including Canada) .
Replace the body control module (BCM). Refer to Control Module References in Computer/Integrating Systems for replacement, setup and programming.Did you complete the replacement?		 Go to Step 5  -
5
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 Go to Step 2  System OK
scientia non olet · About LEMON Manuals