Conditions for Clearing the DTC

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

A current DTC will clear when the fault is no longer present and the ignition switch is cycled.
A history DTC will clear after 100 consecutive ignition cycles without a fault present.
A scan tool may be used to clear history and current DTCs.

DTC B3106

Step	Action	Yes	No
Schematic Reference: Keyless Entry Schematics Connector End View Reference: Keyless Entry Connector End Views
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2	Does the scan tool display DTC B1003, B3102 or B3103?	Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information	Go to Step 3
3	Replace the remote control door lock receiver (RCDLR). Refer to Control Module References in Computer/Integrating Systems for replacement, setup and programming. Did you complete the replacement?	System OK	-