LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 188 (Body Rear End) >> Repair Instructions >> Wedge Replacement - Liftgate Body Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Liftgate Body Side Wedge
    GM1479946Courtesy of GENERAL MOTORS CORP.
  1. Position the wedge (2) to the body side inner panel and index the locking tab to the body panel.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolt (3).

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  3. Close the liftgate.
scientia non olet · About LEMON Manuals