LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 188 (Body Rear End) >> Repair Instructions >> Weatherstrip Replacement - Rear Quarter Window >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: The rear quarter window weatherstrip service replacement part is a cut-to-fit part. The weatherstrip must be trimmed to fit the window opening and joined together.
    Fig 1: View Of Swing Out Window Weatherstrip
    GM1480113Courtesy of GENERAL MOTORS CORP.
  1. Install the rear quarter window weatherstrip forward joint to the vehicle.
  2. Align the rear quarter window weatherstrip forward joint (2) to 50 mm (1.96 in) from the front lower window opening radius.
  3. Roll the rear quarter window weatherstrip from the joint forward around the entire periphery of the window opening flange.
  4. Install the rear quarter window. Refer to Quarter Window Replacement (With A20 Power) or Quarter Window Replacement (Without A20 Manual) in Stationary Windows.
scientia non olet · About LEMON Manuals