LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 188 (Body Rear End) >> Repair Instructions >> Quarter Window Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the upper garnish molding from the body side rear. Refer to Trim Panel Replacement - Body Lock Pillar Upper in Interior Trim.
    2. Fig 1: Locating Bearing Bushing Screw
    GM320147Courtesy of GENERAL MOTORS CORP.
  2. Remove the bearing bushing screw.
    3. Fig 2: Locating Retaining Nuts For Hinge Studs On Rear Quarter Window
    GM320143Courtesy of GENERAL MOTORS CORP.
  3. Remove the retaining nuts from the hinge studs on the rear quarter window.
  4. Remove the rear quarter window from the vehicle.
scientia non olet · About LEMON Manuals