LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 188 (Body Rear End) >> Repair Instructions >> Quarter Window Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear quarter window to the vehicle.
    2. Fig 1: Locating Retaining Nuts For Hinge Studs On Rear Quarter Window
    GM320143Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the retaining nuts to the hinge studs on the rear quarter window.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

    3. Fig 2: Locating Bearing Bushing Screw
    GM320147Courtesy of GENERAL MOTORS CORP.
  3. Install the bearing bushing retaining screw.

    Tighten:  Tighten the screw to 2 N.m (18 lb in).

  4. Install the upper garnish molding top the body side rear. Refer to Trim Panel Replacement - Body Lock Pillar Upper in Interior Trim.
scientia non olet · About LEMON Manuals