LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 188 (Body Rear End) >> Repair Instructions >> Lock Cylinder Replacement - Rear Door (Liftgate) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the liftgate.
  2. Remove liftgate trim panel. Refer to Trim Panel Replacement - Liftgate .
  3. Remove the liftgate handle molding. Refer to Handle Replacement - Liftgate .
    4. Fig 1: Locating Nuts For Lock Cylinder
    GM313609Courtesy of GENERAL MOTORS CORP.
  4. Remove the nuts from the lock cylinder.
    5. Fig 2: View Of Electrical Connector
    GM313608Courtesy of GENERAL MOTORS CORP.
  5. Disconnect electrical connector, if equipped.
  6. Disconnect the lock rod from the cylinder.
  7. Remove the lock cylinder from the liftgate.
scientia non olet · About LEMON Manuals