LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 188 (Body Rear End) >> Repair Instructions >> Latch Replacement - Liftgate >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Liftgate Latch
    GM1479959Courtesy of GENERAL MOTORS CORP.
  1. Install the liftgate latch to the liftgate
  2. Secure the lock cylinder cable (1) into the liftgate latch.
  3. Install the latch cable to the liftgate latch and engage latch cable retainer (2).
  4. Connect the electrical connector to the liftgate latch.
  5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the liftgate latch retainer bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  7. Install the liftgate water deflector. Refer to Water Deflector Replacement - Liftgate .
  8. Close the liftgate.