LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 188 (Body Rear End) >> Repair Instructions >> Handle Replacement - Liftgate >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Liftgate Handle Assembly
    GM1479957Courtesy of GENERAL MOTORS CORP.
  1. Open the liftgate.
  2. Remove the liftgate trim panel. Refer to Trim Panel Replacement - Liftgate .
  3. Remove the water deflector. Refer to Water Deflector Replacement - Liftgate .
  4. Remove the license plate lamp sockets by turning the sockets counterclockwise.
  5. Remove the liftgate handle nuts (1, 2) from the studs inside the liftgate (3).
    6. Fig 2: View Of Liftgate Handle
    GM1479958Courtesy of GENERAL MOTORS CORP.
  6. Remove the bolts (2) from the liftgate handle.
  7. Remove the liftgate latch cable from the handle.
  8. Remove the liftgate handle from the liftgate.
  9. Remove the liftgate handle gasket and discard.
scientia non olet · About LEMON Manuals